HOLDS YOUR MOTOR AT THE EXACT ANGLE & OFFSET for optimal chain alignment... Made of STURDY Aircraft Aluminum. Allows for several inches of [forward or backward <-> slide] to make drive chain and bicycle side chain "match up" much faster and easier...
SPOILER MOUNT REQUIRES AN EXTRA BRACKET FOR REAR - SEE BOX BELOW
Includes: All stainless steel mounting hardware. Also, grade 12.9 [hardest metric bolts] for attaching motor to mounts.
Note: Jackshaft component shown in photo [below] not included with this purchase.
$89.99
[ADAPTOR OMLY] Small rectangular machined fittings in [PHOTO - IN FRONT OF MOTOR] These Adaptors allow you to adapt our Stingray Specific machined motor mount to fit the WIDER MOUTH Motors. Check the measurement on the front STUDS ON YOUR MOTOR.... If the measurement is around 1 1/2 inches [center to center ] of bolt holes or studs NO ADAPTOR NEEDED... If measurementis 2 inches - you will need our 2 inch adaptor. If you have a NEW Grubee GT5A or similar and the measurement is 2 1/2 inches = you will need our 2 1/2 inch adaptor.... comes with needed hardened mounting bolts.
$21.98
Finally special rear mounting plate to accomodate the larger 8mm rear mounting studs on ZEDA model motors.... This combined with our [2 inch] front adaptor - allow you to mount your ZEDA motor onto the NEW ERA schwinn Stingray frame.
$99.99
QUESTIONS? Contact us through the form below.